Oce CS2436 User Manual - Specifying Netware Protocols
Network Setting (CS2436-9)
9. 2. 6.
Network Setting > Network Setting (Windows) >
Specifying NetWare Protocols
Follow the steps below to configure NetWare protocol settings other than the frame type by using
RemoteUI.
Note
･
For details on RemoteUI, see "Using RemoteUI (
9.1.7
)."
1.
Start the web browser and enter the following URL in the
Location
(or
Address
) box to
display the RemoteUI page.
http://
printer IP address or name
/
Example: http://xxx.xxx.xxx.xxx/
2.
Select
Administrator Mode
and click
Logon
.
3.
If a password has been set on the printer, enter the password.
4.
Click
Network
in the
Device Manager
menu at left to display the
Network
page.
5.
Click
Edit
in the upper-right corner of the
NetWare
group to display the
Edit NetWare
Protocol Settings
page.
6.
Make sure the
Frame Type
indicates the frame type used on the NetWare network.
7.
To use burst mode, choose
On
for
NCP Burst Mode
.
Note
･
Burst mode supports fast data transfer when printing in queue server
mode. Normally, choose
On
.
8.
In
Print Application
, click the print service to be used.
Note
･
Only one print service selected here will be enabled. Multiple print
services are not available at the same time.
9.
For packet signature, click
If Requested by Server
in
Packet Signature
.
10.
Complete the following settings based on the selected service.
●
If you have selected Bindery PServer: Queue Server Mode (Using a Bindery Print
Server)
1.
In
File Server Name
, enter the file server name.
2.
In
Print Server Name
, enter the name of the print server created in
3]
file:///H|/ITC-dd/Projects/Ud/WFPS/oostende%205/...port/iPF750%20User%20Manual/lang/print/cp06.html (44 of 60) [4-3-2010 11:37:0