Oce CS2436 User Manual - page 567
Network Setting (CS2436-9)
・
If you specify to configure the IP address using DHCP, BOOTP, or RARP,
there must be a server that supports such protocol running in the network.
・
If you specify to configure the IP address using DHCP, BOOTP, or RARP,
the IP address obtained by this method is used first. If you cannot obtain the
IP address, the address specified in
IP Address
is used.
・
It takes up to two minutes to determine whether DHCP, BOOTP, or RARP
are available. We recommend clearing check boxes of options you will not use.
・
If you are using a DNS server, select
Enable DNS Dynamic Update
and
enter the IP Address for DNS servers, DNS host name, and DNS domain
name in
Primary DNS Server Address
,
Secondary DNS Server
Address
,
DNS Host Name
, and
DNS Domain Name
, respectively.
When using an IPv6 IP address
1.
Start the web browser and enter the following URL in the
Location
(or
Address
) box to
display the RemoteUI page.
http://
printer IP address or name
/
Example: http://xxx.xxx.xxx.xxx/
2.
Select
Administrator Mode
and click
Logon
.
3.
If a password has been set on the printer, enter the password.
4.
Click
Network
in the
Device Manager
menu at left to display the
Network
page.
5.
Click
Edit
in the upper-right corner of the
TCP/IPv6
group to display the
Edit TCP/IP
Protocol Settings
page.
6.
Refer to the TCP/IP Settings Items table to complete the settings.
TCP/IP Settings Items
Item
Details
Default Setting
Use IPv6
Activate to enable
IPv6.
Off
Use DHCPv6
Activate when using a
DHCP server to
acquire the IP address.
Off
Use a stateless
address
Activate when using
an IPv6-compatible
router to acquire the
IP address.
On
Use a manual
address
Activate when
configuring the IP
address manually.
Off
3]
file:///H|/ITC-dd/Projects/Ud/WFPS/oostende%205/...port/iPF750%20User%20Manual/lang/print/cp06.html (17 of 60) [4-3-2010 11:37:0