Oce CS2436 User Manual - page 577
Network Setting (CS2436-9)
9. 1. 12.
Network Setting > Network Setting >
Configuring the Communication Mode Manually
This topic gives instructions for configuring the communication mode manually.
1.
On the
Tab Selection screen
of the Control Panel, press or to select the Settings/
Adj. tab (
).
Note
・
If the
Tab Selection screen
is not displayed, press the
Menu
button.
2.
Press the
OK
button.
The
Set./Adj. Menu
is displayed.
3.
Press or to select
Interface Setup
, and then press the
OK
button.
4.
Press or to select
Ethernet Driver
, and then press the
OK
button.
5.
Press or to select
Auto Detect
, and then press the
OK
button.
6.
Press or to select
Off
, and then press the
OK
button.
The display reverts to the
Ethernet Driver
menu.
7.
Press or to select
Comm.Mode
, and then press the
OK
button.
8.
Press or to select the communication mode, and then press the
OK
button.
The display reverts to the
Ethernet Driver
menu.
9.
Press or to select
Ethernet Type
, and then press the
OK
button.
10.
Press or to select the Ethernet type, and then press the
OK
button.
The display reverts to the
Ethernet Driver
menu.
11.
Press or to select
Spanning Tree
, and then press the
OK
button.
12.
Press or to enable or disable spanning tree support, and then press the
OK
button.
The display reverts to the
Ethernet Driver
menu.
13.
Press the
Menu
button.
After the confirmation message is displayed, press the
OK
button.
The new settings will take effect after the printer restarts.
3]
file:///H|/ITC-dd/Projects/Ud/WFPS/oostende%205/...port/iPF750%20User%20Manual/lang/print/cp06.html (27 of 60) [4-3-2010 11:37:0