Oce CS2436 User Manual - page 588
Network Setting (CS2436-9)
9. 2. 4.
Network Setting > Network Setting (Windows) >
Specifying the Printer's Frame Type
To enable communication between the printer and computers on your network, specify the
Ethernet frame type in your NetWare environment.
Follow these steps to specify the frame type by using Device Setup Utility or the printer Control
Panel.
Note
・
You can specify the frame type by using RemoteUI if the printer's IP
address is configured.
Important
・
Before specifying the frame type, make sure the printer is on and
connected to the network.
・
For instructions on installing Device Setup Utility, see "Installing Device
Setup Utility (
9.2.8
)."
Specifying the frame type using Device Setup Utility
1.
Start Device Setup Utility.
2.
In the list of printers, select the printer to configure.
3.
Choose
Protocol Settings
from the
Printer
menu.
4.
Click the
NetWare
tab and select the frame type in the
NetWare Frame Type
list.
5.
Click the
IPv4
tab and select
ETHERNET II
in the
Frame Type
list.
6.
In
IP Address
, enter the IP address assigned to the printer, and then enter the subnet
mask in
Subnet Mask
and the default gateway in
Gateway Address
.
Important
・
You must specify the IP address here to be able to configure
NetWare protocol settings using RemoteUI.
7.
Click
Set
.
8.
Click
OK
after the
Confirmation
message is displayed.
9.
Exit Device Setup Utility.
Specifying the frame type using the printer Control Panel
3]
file:///H|/ITC-dd/Projects/Ud/WFPS/oostende%205/...port/iPF750%20User%20Manual/lang/print/cp06.html (38 of 60) [4-3-2010 11:37:0