Oce CS2436 User Manual - page 698
Troubleshooting (CS2436-11)
11. 5. 7.
Troubleshooting > Problems with the printing quality >
Banding in different colors occurs
Cause
Corrective Action
The paper feed amount is
out of adjustment.
Adjust the feed amount.
(See "Adjusting the Feed Amount (
7.2.1
).")
Printing does not proceed
smoothly because print jobs
are interrupted during
transmission.
Exit other applications and cancel other
print jobs.
In the Control Panel menu,
Adj. Priority
is set to
Length
.
Setting
Adj. Priority
to
Print Quality
in
the Control Panel menu and adjusting the
feed amount may improve results.
(See "Adjusting the Feed Amount (
7.2.1
).")
The Printhead is out of
alignment.
Adjust the Printhead alignment.
(See "Automatic Adjustment to Straighten
Lines and Colors (Head Posi. Adj.) (
7.1.2
).")
The Printhead nozzles are
clogged.
Print a test pattern to check the nozzles
and see if they are clogged.
(See "Checking for Nozzle
Clogging (
10.2.2
).")
Streaks may occur if you set
the
Print Quality
too low.
Choose a higher level of
Print Quality
in
the
Advanced Settings
of the printer
driver and try printing again.
Printing in
Draft
or
Standard
mode is
faster and consumes less ink than in
Highest
or
High
modes, but the printing
quality is lower.
(See "Giving Priority to Particular Graphic
Elements and Colors for Printing (
3.1.4
).")
The type of paper specified
in the printer driver does not
match the type loaded in the
printer.
Load paper of the same type as you have
specified in the printer driver.
(See "Loading Rolls in the Printer (
6.2.2
).")
(See "Loading Sheets in the
Printer (
6.3.1
).")
2]
file:///H|/ITC-dd/Projects/Ud/WFPS/oostende%205/...port/iPF750%20User%20Manual/lang/print/cp08.html (40 of 75) [4-3-2010 11:37:2