Oce CS2436 User Manual - page 490
Adjustments for Better Print Quality (CS2436-7)
7. 2. 5.
Adjustments for Better Print Quality > Adjusting the feed amount >
Adjusting Line Length (Adjust Length)
To ensure that lines in CAD drawings are printed at exactly the right length, use
Adjust Length
to adjust the amount that paper is advanced.
There are two options in
Adjust Length
:
AdjustmentPrint
and
Change Settings
.
●
AdjustmentPrint
After a test pattern is printed, you will measure the discrepancy based on the results of
printing.
●
Change Settings
No test pattern is printed. Instead, you will measure a document already printed to
determine the discrepancy.
Additionally, two modes are available in both
AdjustmentPrint
and
Change Settings
:
A:High
or
B:Standard/Draft
. Choose the mode that suits your particular printing application.
●
A:High
This setting is applied when
Highest
or
High
is selected in
Print Quality
in the printer
driver.
●
B:Standard/Draft
This setting is applied when
Standard
or
Draft
is selected in
Print Quality
in the printer
driver.
Note
・
Always check the
Adj. Priority
values before using
Adjust Length
. (See
"Selecting a Feed Amount Adjustment Method (Feed Priority) (
7.2.2
).")
・
Use paper of the same type and size for adjustment as you will use for
printing.
Paper to Prepare
Rolls
・
An unused roll at least 10 inches wide
・
High-precision ruler
Sheets
・
One sheet of unused paper of at least A4/Letter size
・
High-precision ruler
Perform adjustment as follows.
1.
Load the paper.
●
Attaching the Roll Holder to Rolls (
6.2.1
)
file:///H|/ITC-dd/Projects/Ud/WFPS/oostende%205/...port/iPF750%20User%20Manual/lang/print/cp70.html (22 of 25) [4-3-2010 11:36:36]