D-Link xStack DXS-3350SR Installation & User Manual - Traffic Segmentation
DXS-3350SR Gigabit Layer 3 Switch
Traffic Segmentation
Traffic segmentation is used to limit traffic flow from a single port to a group of ports on either a single Switch (in
standalone mode) or a group of ports on another Switch in a Switch stack (Single IP). This method of segmenting the flow
of traffic is similar to using VLANs to limit traffic, but is more restrictive. Any port can be configured to forward traffic to
only the selected ports.
In the Configuration folder open the QoS folder and click Traffic Segmentation, to view the menu shown below.
Figure 6- 48. Traffic Segmentation Setting and Traffic Segmentation Table
Select the Unit and Port on which you will configure traffic segmentation and click the Setup button. The Setup
Forwarding Ports menu appears. Use this menu to determine which port on a given Switch will be allowed to forward
packets to other ports on that Switch.
Figure 6- 49. Traffic Segmentation Setup
96