D-Link xStack DXS-3350SR Installation & User Manual - page 69
DXS-3350SR Gigabit Layer 3 Switch
A router port will be dynamically configured when IGMP query packets, RIPv2 multicast, DVMRP multicast or PIM-DM
multicast packets are detected flowing into a port.
Open the IGMP folder and the click on the Static Router Ports Entry link to open the Current Static Router Ports
Entries page, as shown below.
Figure 6- 16. Current Static Router Ports Entries window
The Current Static Router Ports Entries page (shown above) displays all of the current entries to the Switch's static router
port table. To modify an entry, click the Modify button. This will open the Static Router Ports Settings page, as shown
below.
Figure 6- 17. Static Router Ports Settings window
The following parameters can be set:
Parameter Description
VID (VLAN ID)
This is the VLAN ID that, along with the VLAN Name, identifies the VLAN where the
multicast router is attached.
VLAN Name
This is the name of the VLAN where the multicast router is attached.
Unit
Select the unit in the stack you want to configure.
Member Ports
There are the ports on the Switch that will have a multicast router attached to them.
Click Apply to implement the new settings, Click the
Show All Static Router Port Entries
link to return to the Current
Static Router Port Entries window.
60