D-Link xStack DXS-3350SR Installation & User Manual - L3 Global Advanced Settings
DXS-3350SR Gigabit Layer 3 Switch
Configuring Layer 3 IP Networking
To access the Layer 3 IP Networking links, open the Configuration folder and then the Layer 3 IP Networking folder.
L3 Global Advanced Settings
The L3 Global Advanced Settings window allows the user to enable and disable Layer 3 settings and functions from a
single window. The full settings and descriptions for these functions will appear later in this section To view this window,
open the Configuration folder and then the Layer 3 IP Networking folder and click on the L3 Global Advanced Settings
link to access the following window.
Figure 6- 78. L3 Global Advanced Settings
The user may set the following:
Parameter
Description
DVMRP State
The user may globally enable or disable the Distance Vector Multicast Routing
Protocol (DVMRP) function by using the pull down menu.
PIM-DM State
The user may globally enable or disable the Protocol Independent Multicast –
Dense Mode (PIM-DM) function by using the pull down menu.
RIP State
The user may globally enable or disable the Routing Information Protocol (RIP)
function by using the pull down menu.
OSPF State
The user may globally enable or disable the Open Shortest Path first (OSPF)
function by using the pull down menu.
ARP Aging Time
The user may globally set the maximum amount of time in minutes that an Address
Resolution Protocol (ARP) entry can remain in the Switch's ARP table, without being
accessed, before it is dropped from the table. The value may be set in the range of
0-65535 minutes with a default setting of 20 minutes.
128