D-Link xStack DXS-3350SR Installation & User Manual - page 184
DXS-3350SR Gigabit Layer 3 Switch
The following fields can be set:
Parameter
Description
Interface Name <System>
Displays the name of the IP interface that is to be configured for IGMP. This
must be a previously configured IP interface.
IP Address
Displays the IP address corresponding to the IP interface name above.
Version <2>
Enter the IGMP version (1 or 2) that will be used to interpret IGMP queries on
the interface.
Query Interval(1-65535) <125> Allows the entry of a value between 1 and 65535 seconds, with a default of
125 seconds. This specifies the length of time between sending IGMP queries.
Max Response Time(1-25)
<10>
Sets the maximum amount of time allowed before sending an IGMP response
report. A value between 1 and 25 seconds can be entered, with a default of 10
seconds.
Robustness Variable(1-255)
<2>
A tuning variable to allow for subnetworks that are expected to lose a large
number of packets. A value between 1 and 255 can be entered, with larger
values being specified for subnetworks that are expected to lose larger
numbers of packets. Although a value of one (1) can be entered, this may
result in problems and is not recommended. The default setting is 2.
Last Member Query
Interval(1-25) <1>
Specifies the maximum amount of time between group-specific query
messages, including those sent in response to leave group messages. A value
between 1 and 25. The default is 1 second.
State <Disabled>
This field can be toggled between Enabled and Disabled and enables or
disables IGMP for the IP interface. The default is Disabled.
175