D-Link xStack DXS-3350SR Installation & User Manual - Global Ospf Settings
DXS-3350SR Gigabit Layer 3 Switch
Global OSPF Settings
The OSPF General Setting menu allows OSPF to be enabled or disabled on the Switch
− without changing the Switch’s
OSPF configuration.
From the Layer 3 IP Networking folder, open the OSPF folder and click on the General link. To enable OSPF, first
supply an OSPF Route ID (see below), select Enabled from the State drop-down menu and click the Apply button.
Figure 6- 91OSPF General Setup window
The following parameters are used for general OSPF configuration:
Parameter
Description
OSPF Route ID
A 32-bit number (in the same format as an IP address
− xxx.xxx.xxx.xxx) that uniquely
identifies the Switch in the OSPF domain. It is common to assign the highest IP
address assigned to the Switch (router). In this case, it would be 10.255.255.255, but
any unique 32-bit number will do. If 0.0.0.0 is entered, the highest IP address assigned
to the Switch will become the OSPF Route ID.
Current Route ID
Displays the OSPF Route ID currently in use by the Switch. This Route ID is displayed
as a convenience to the user when changing the Switch’s OSPF Route ID.
State
Allows OSPF to be enabled or disabled globally on the Switch without changing the
OSPF configuration.
Note: In order for this window to function properly, the OSPF State must be
globally enabled under Layer 3 IP Networking > L3 Global Advanced
Settings.
158