D-Link xStack DXS-3350SR Installation & User Manual - page 75
DXS-3350SR Gigabit Layer 3 Switch
Figure 6- 20. Instance ID Settings window- Add
The user may configure the following parameters to create a MSTI in the Switch.
Parameter
Description
MSTI ID
Enter a number between 1 and 15 to set a new MSTI on the Switch.
Type
Create is selected to create a new MSTI. No other choices are available for this field
when creating a new MSTI.
VID List (1-4094)
This field is used to specify the VID range from configured VLANs set on the Switch.
Supported VIDs on the Switch range from ID number 1 to 4094.
Click Apply to implement changes made.
To configure the settings for the CIST, click on its hyperlinked name in the Current MST Configuration Identification
window, which will reveal the following window to configure:
Figure 6- 21. Instance ID Settings - modify CIST
The user may configure the following parameters to configure the CIST on the Switch.
Parameter
Description
MSTI ID
The MSTI ID of the CIST is 0 and cannot be altered.
Type
The type of configuration about to be processed. This window is used to set the
priority for the CIST only. All other parameters are permanently set and therefore
unchangeable.
VID List (1-4094)
This field is used to specify the VID range from configured VLANs set on the Switch.
Supported VIDs on the Switch range from ID number 1 to 4094. This field is
inoperable when configuring the CIST.
Click Apply to implement changes made.
66