D-Link xStack DXS-3350SR Installation & User Manual - Firmware Information
DXS-3350SR Gigabit Layer 3 Switch
open the Firmware Information link. The default setting for the Switch’s firmware will have the boot up firmware stored
in Image 1, but the user may set either firmware stored to be the boot up firmware by using the Config Firmware Image
window.
Firmware Information
The following window allows the user to view information about current firmware images stored on the Switch. To access
the following window, click Maintenance > Multiple Image Services > Firmware Information.
Figure 8- 3 . Firmware Information window
7
This window holds the following information:
Parameter
Description
BOX
States the stacking ID number of the switch in the switch stack.
ID
States the image ID number of the firmware in the Switch’s memory. The Switch can
store 2 firmware images for use. Image ID 1 will be the default boot up firmware for
the Switch unless otherwise configured by the user.
Version
States the firmware version.
Size
States the size of the corresponding firmware, in bytes.
Update Time
States the specific time the firmware version was downloaded to the Switch.
From
States the IP address of the origin of the firmware. There are four ways firmware may
be downloaded to the Switch.
R – If the IP address has this letter attached to it, it denotes a firmware upgrade
through the Console Serial Port (RS-232).
T - If the IP address has this letter attached to it, it denotes a firmware upgrade
through Telnet.
S - If the IP address has this letter attached to it, it denotes a firmware upgrade
through the Simple Network Management Protocol (SNMP).
W - If the IP address has this letter attached to it, it denotes a firmware upgrade
through the web-based amangement interface.
User
States the user who downloaded the firmware. This field may read “Anonymous” or
“Unknown” for users that are not identified.
245