D-Link xStack DXS-3350SR Installation & User Manual - Config Firmware Image
DXS-3350SR Gigabit Layer 3 Switch
Config Firmware Image
The Config Firmware Image window allows users to configure firmware images saved in the memory of the Switch. To
access the following window, click Maintenance > Multiple Image Services > Config Firmware Image.
Figure 8- 3 . Config Firmware Image window
8
This window offers the following information:
Parameter
Description
Image
Select the firmware image to be configured using the pull-down menu. The Switch
allows two firmware images to be stored in the Switch’s memory.
Active
This field has two options for configuration.
Delete – Select this option to delete the firmware image specified in the Image
field above.
Boot – Select this option to set the firmware image specified above as the boot up
firmware for the Switch. This firmware will be set as the boot up firmware
after a switch reboot has been performed. The default setting has firmware
image ID 1 as the boot up firmware image for the Switch unless specified
here.
Click Apply to implement changes made.
Ping Test
Ping is a small program that sends ICMP Echo packets to the IP address you specify. The destination node then responds to
or "echoes" the packets sent from the Switch. This is very useful to verify connectivity between the Switch and other nodes
on the network.
Figure 9- 5. Ping Test
The user may use Infinite times radio button, in the Repeat Pinging for: field, which will tell the ping program to keep
sending ICMP Echo packets to the specified IP address until the program is stopped. The user may opt to choose a specific
number of times to ping the Target IP Address by clicking its radio button and entering a number between 1 and 255.
Click Start to initiate the Ping program.
246