D-Link xStack DXS-3350SR Installation & User Manual - Features
DXS-3350SR Gigabit Layer 3 Switch
Features
• Support broadcast storm filtering
• Non-blocking store and forward switching scheme capability to support rate adaptation and protocol conversion
• Supports by-port Egress/Ingress rate control
• Efficient self-learning and address recognition mechanism enables forwarding rate at wire speed
• Support port-based enable and disable
• Address table: Supports up to 16K MAC addresses per device
• Supports a packet buffer of up to 4 Mbits
• Supports Port-based VLAN Groups
• Port Trunking with flexible load distribution and fail-over function
• IGMP Snooping support
• Layer 3 support including DVMRP, OSPF and RIP
• SNMP support
• Secure Sockets Layer (SSL) and Secure Shell (SSH) support
• Port Mirroring support
• MIB support for:
• RFC1213 MIB II
• RFC1493 Bridge
• RFC1757 RMON
• RFC1643 Ether-like MIB
• RFC2233 Interface MIB
• IF MIB
• Private MIB
• RFC2674 for 802.1p
• IEEE 802.1x MIB
• RS-232 DCE console port for Switch management
• IEEE 802.3z compliant
• IEEE 802.3x Flow Control in full-duplex compliant
• IEEE 802.3u compliant
• IEEE 802.3ab compliant
• IEEE 802.3ae compliant (for optional XFP module)
• IEEE 802.1p Priority Queues
• IEEE 802.3ad Link Aggregation Control Protocol support.
• IEEE 802.1x Port-based and MAC-based Access Control
• IEEE 802.1Q VLAN
• IEEE 802.1D Spanning Tree, IEEE 802.1W Rapid Spanning Tree and IEEE 802.1s Multiple Spanning Tree
support
• Stacking support in either Ring or Star topology
• Access Control List (ACL) support
• IP Multinetting support
• Protocol VLAN support
• Single IP Management support
• Access Authentication Control utilizing TACACS, XTACACS, TACACS+ and RADIUS protocols
• Dual Image Firmware
• Simple Network Time Protocol support
• MAC Notification support
• System and Port Utilization support
• System Log Support
• High performance switching engine performs forwarding and filtering at full wire speed up to 176Gbps.
• Full- and half-duplex for all gigabit ports. Full duplex allows the switch port to simultaneously transmit and
receive data. It only works with connections to full-duplex-capable end stations and switches. Connections to a
hub must take place at half-duplex.
8
• Provides parallel LED display for port status such as link/act, speed, etc.