D-Link xStack DXS-3350SR Installation & User Manual - Sim Using The Web Interface
DXS-3350SR Gigabit Layer 3 Switch
It is not a CS or MS of another IP group.
It is connected to the CS through the CS management VLAN.
3. Candidate Switch(CaS) - This is a Switch that is ready to join a SIM group but is not yet a member of the SIM
group. The Candidate Switch may join the SIM group through an automatic function of the DXS-3350SR, or by
manually configuring it to be a MS of a SIM group. A Switch configured as a CaS is not a member of a SIM group
and will take on the following characteristics:
It is not a CS or MS of another Single IP group.
It is connected to the CS through the CS management VLAN
The following rules also apply to the above roles:
Each device begins in a Commander state.
CS's must change their role to CaS and then to MS, to become a MS of a SIM group. Thus the CS cannot directly be
converted to a MS.
The user can manually configure a CS to become a CaS.
A MS can become a CaS by:
Being configured as a CaS through the CS.
If report packets from the CS to the MS time out.
The user can manually configure a CaS to become a CS
The CaS can be configured through the CS to become a MS.
After configuring one Switch to operate as the CS of a SIM group, additional DXS-3350SR Switches may join the group
either by an automatic method or by manually configuring the Switch to be a MS. The CS will then serve as the in band
entry point for access to the MS. The CS's IP address will become the path to all MS's of the group and the CS's
Administrator's password, and/or authentication will control access to all MS's of the SIM group.
With SIM enabled, the applications in the CS will redirect the packet instead of executing the packets. The applications will
decode the packet from the administrator, modify some data, then send it to the MS. After execution, the CS may receive a
response packet from the MS, which it will encode and send it back to the administrator.
When a CaS becomes a MS, it automatically becomes a member of the first SNMP community (include read/write and read
only) to which the CS belongs. However, if a MS has its own IP address, it can belong to SNMP communities to which
other Switches in the group, including the CS, do not belong.
SIM Using The Web Interface
All DXS-3350SR Switches are set as Candidate (CaS) Switches as their factory default configuration and Single IP
Management will be disabled. To enable SIM for the Switch using the Web interface, go to the Single IP Management
folder and click the SIM Settings link, revealing the following window.
Figure 10- 1. SIM Settings window (disabled)
Change the SIM State to Enabled using the pull down menu and click Apply. The screen will then refresh and the SIM
Settings window will look like this:
251