D-Link xStack DXS-3350SR Installation & User Manual - page 117
DXS-3350SR Gigabit Layer 3 Switch
This screen will aid the user in configuring the Switch to mask packet headers beginning with the offset value specified. The
following fields are used to configure the Packet Content Mask:
Parameter
Description
Profile ID(1- 8)
Type in a unique identifier number for this profile set. This value can be set from 1 - 8.
Type
Select profile based on Ethernet (MAC Address), IP address or packet content mask.
This will change the menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet
header.
Select IP to instruct the Switch to examine the IP address in each frame's header.
Select Packet Content Mask to specify a mask to hide the content of the packet
header.
Offset
This field will instruct the Switch to mask the packet header beginning with the offset
value specified:
value (0-15) - Enter a value in hex form to mask the packet from the beginning of the
packet to the 16th byte.
value (16-31) – Enter a value in hex form to mask the packet from byte 16 to byte 31.
value (32-47) – Enter a value in hex form to mask the packet from byte 32 to byte 47.
value (48-63) – Enter a value in hex form to mask the packet from byte 48 to byte 63.
value (64-79) – Enter a value in hex form to mask the packet from byte 64 to byte 79.
Port
The user may set the Access Profile Tableon a per-port basis by entering a port
number in this field. Stackable Switches must specify the Unit number and Port
number separated by a semicolon (for example 1:34 specifies port thirty-four on
Switch number one). Enter all to apply to all ports on this Switch.
Click Apply to implement changes made.
To establish the rule for a previously created Access Profile:
In the Configuration folder, click the Access Profile Table link opening the Access Profile Table. Under the heading
Access Rule, clicking Modify, will open the following window.
Figure 6- 58. Access Rule Table window
To create a new rule set for an access profile click the Add button. A new window is displayed. To delete a profile
configuration, click the corresponding under the Delete heading in the access rule table.
108