D-Link xStack DXS-3350SR Installation & User Manual - Static Multicast Forwarding
DXS-3350SR Gigabit Layer 3 Switch
Static Multicast Forwarding
The following figure and table describe how to set up Multicast Forwarding on the Switch. Open the Forwarding
Filtering folder and click on the Multicast Forwarding link to see the entry screen below:
Figure 6- 29. Static Multicast Forwarding Settings and Current Multicast Forwarding Entries
The Static Multicast Forwarding Settings page displays all of the entries made into the Switch's static multicast
forwarding table. Click the Add button to open the Setup Static Multicast Forwarding Table, as shown below:
Figure 6- 30. Setup Static Multicast Forwarding Table
The following parameters can be set:
Parameter
Description
Unit
Select the unit in the stack you want to configure.
VID
The VLAN ID of the VLAN the corresponding MAC address belongs to.
Multicast MAC
Address
The MAC address of the static source of multicast packets. This must be a multicast
MAC address.
Port Settings
Allows the selection of ports that will be members of the static multicast group. The
options are:
None - No restrictions on the port dynamically joining the multicast group. When None
is chosen, the port will not be a member of the Static Multicast Group.
Egress - The port is a static member of the multicast group.
Click Apply to implement the changes made. To delete an entry in the Static Multicast Forwarding Table, click the
corresponding under the Delete heading.
73