D-Link xStack DXS-3350SR Installation & User Manual - Rip Configuration
DXS-3350SR Gigabit Layer 3 Switch
Because the version number in RIP2 occupies the same octet as in RIP1, both versions of the protocols can be used on a
given router simultaneously without interference.
RIP Configuration
To setup RIP for the IP interfaces configured on the Switch, the user must enable RIP and then configure RIP settings for
the individual IP interfaces. To globally enable RIP on the Switch, open the Configuration folder to Layer 3 Networking
and then open the RIP folder and click on the RIP Configuration link to access the following screen:
Figure 6- 88. RIP Global Setting window
To enable RIP, simply use the pull down menu, select Enabled and click Apply.
Setting Up RIP
RIP settings are configured for each IP interface on the Switch. Click the RIP Interface Settings link in the RIP folder. The
menu appears in table form listing settings for IP interfaces currently on the Switch. To configure RIP settings for an
individual interface, click on the hyperlinked Interface Name. To view the next page of RIP Interface Settings, click the
Nextbutton.
Figure 6- 89. RIP Interface Settings window
Click the hyperlinked name of the interface you want to set up for RIP, which will give access to the following menu:
Figure 6- 90. RIP Interface Settings - Edit window
Refer to the table below for a description of the available parameters for RIP interface settings.
140