D-Link xStack DXS-3350SR Installation & User Manual - Lacp Port Setting
DXS-3350SR Gigabit Layer 3 Switch
LACP Port Setting
The LACP Port Setting window is used in conjunction with the Link Aggregation window to create port trunking groups
on the Switch. Using the following window, the user may set which ports will be active and passive in processing and
sending LACP control frames.
Figure 6- 11. LACP Port Settings and LACP Port Table
The user may set the following parameters:
Parameter Description
Unit
Select the unit in the stack you want to configure.
From/To
A consecutive group of ports may be configured starting with the selected port.
Mode
Active - Active LACP ports are capable of processing and sending LACP control
frames. This allows LACP compliant devices to negotiate the aggregated link so the
group may be changed dynamically as needs require. In order to utilize the ability to
change an aggregated port group, that is, to add or subtract ports from the group, at
least one of the participating devices must designate LACP ports as active. Both
devices must support LACP.
Passive - LACP ports that are designated as passive cannot initially send LACP
control frames. In order to allow the linked port group to negotiate adjustments and
make changes dynamically, one end of the connection must have "active" LACP ports
(see above).
After setting the previous parameters, click Apply to allow your changes to be implemented. The LACP Port Table shows
which ports are active and/or passive.
55