D-Link xStack DXS-3350SR Installation & User Manual - Authentication Server Hosts
DXS-3350SR Gigabit Layer 3 Switch
Authentication Server Hosts
This window will set user-defined Authentication Server Hosts for the TACACS / XTACACS / TACACS+ / RADIUS
security protocols on the Switch. When a user attempts to access the Switch with Authentication Policy enabled, the Switch
will send authentication packets to a remote TACACS / XTACACS / TACACS+ / RADIUS server host on a remote host.
The TACACS / XTACACS / TACACS+ / RADIUS server host will then verify or deny the request and return the
appropriate message to the Switch. More than one authentication protocol can be run on the same physical server host but,
remember that TACACS / XTACACS / TACACS+ / RADIUS are separate entities and are not compatible with each other.
The maximum supported number of server hosts is 16.
To view the following window, click Security Management > Access Authentication Control > Authentication Server
Host:
Figure 7- 9. Authentication Server Host Settings window
To add an Authentication Server Host, click the Add button, revealing the following window:
Figure 7- 10. Authentication Server Host Settings window – Add
187