D-Link xStack DXS-3350SR Installation & User Manual - page 55
DXS-3350SR Gigabit Layer 3 Switch
Parameter
Description
Serial Port Auto
Logout Time
Select the logout time used for the console interface. This automatically logs the user
out after an idle period of time, as defined. Choose from the following options: 2
Minutes, 5 Minutes, 10 Minutes, 15 Minutes or Never. The default setting is 10
minutes.
MAC Address Aging
Time
This field specifies the length of time a learned MAC Address will remain in the
forwarding table without being accessed (that is, how long a learned MAC Address is
allowed to remain idle). The default age-out time for the Switch is 300 seconds. To
change this, type in a different value representing the MAC address age-out time in
seconds. The MAC Address Aging Time can be set to any value between 10 and
1,000,000 seconds. The default setting is 300 seconds.
IGMP Snooping
To enable system-wide IGMP Snooping capability select Enabled. IGMP snooping is
Disabled by default. Enabling IGMP snooping allows you to specify use of a multicast
router only (see below). To configure IGMP Snooping for individual VLANs, use the
IGMP Snooping page under the IGMP folder.
Multicast router Only Enable to support Multicast router only.
GVRP Status
Use this pull-down menu to enable or disable GVRP on the Switch.
Telnet Status
Telnet configuration is Enabled by default. If you do not want to allow configuration of
the system through Telnet choose Disabled.
TCP Port Number (1-
65535)
The TCP port number. TCP ports are numbered between 1 and 65535. The "well-
known" TCP port for the Telnet protocol is 23.
Web Status
Web-based management is Enabled by default. If you choose to disable this by select-
ing Disabled, you will lose the ability to configure the system through the web interface
as soon as these settings are applied.
Web TCP Port
Number
The TCP port number currently being utilized by the Switch to connect to the web
interface. The "well-known" TCP port for the Web interface is 80.
Link Aggregation
Algorithm
The algorithm that the Switch uses to balance the load across the ports that make up
the port trunk group is defined by this definition. Choose MAC Source, MAC
Destination, MAC Src & Dest, IP Source, IP Destination or IP Src & Dest (See the Link
Aggregation section of this manual).
RMON Status
Remote monitoring (RMON) of the Switch is Enabled or Disabled here.
802.1x Status
Enables or disables 802.1x for MAC-based or Port-based 802.1x function; default is
Disabled. Port-based 802.1x function will base authentiaction base only on the port
number. MAC-based 802.1x function uses the port number and specified MAC
address as configured in the 802.1x Intitialize Ports menu. See the section on 802.1x
configuration below.
Auth. Protocol
The user may use the pull down menu to choose between Local Eap and Radius Eap
for the 802.1x authentication protocol on the Switch. The default setting is Radius eap.
HOL Prevention
Enables or disables Head Of Line prevention.
Jumbo Frame
Enables or disables support for Jumbo Frames up to 9216 bytes.
Syslog Global State
Enables or disables Syslog State; default is Disabled.
Click Apply to implement changes made.
46