D-Link xStack DXS-3350SR Installation & User Manual - page 113
DXS-3350SR Gigabit Layer 3 Switch
The following parameters can be set, for the Ethernet type:
Parameter
Description
Profile ID (1-8)
Type in a unique identifier number for this profile set. This value can be set from 1 - 8.
Type
Select profile based on Ethernet (MAC Address), IP address or packet content mask.
This will change the menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet
header.
Select IP to instruct the Switch to examine the IP address in each frame's header.
Select Packet Content Mask to specify a mask to hide the content of the packet
header.
VLAN
Selecting this option instructs the Switch to examine the VLAN identifier of each
packet header and use this as the full or partial criterion for forwarding.
Source Mac
Source MAC Mask - Enter a MAC address mask for the source MAC address.
Destination Mac
Destination MAC Mask - Enter a MAC address mask for the destination MAC
address.
802.1p
Selecting this option instructs the Switch to examine the 802.1p priority value of each
packet header and use this as the, or part of the criterion for forwarding.
Ethernet type
Selecting this option instructs the Switch to examine the Ethernet type value in each
frame's header.
Port
The user may set the Access Profile Tableon a per-port basis by entering a port
number in this field. Enter all to apply to all ports on this Switch.
The page shown below is the IP Access Profile Configuration page.
104