D-Link xStack DXS-3350SR Installation & User Manual - Ospf Host Route Settings
DXS-3350SR Gigabit Layer 3 Switch
OSPF Host Route Settings
OSPF host routes work in a way analogous to RIP, only this is used to share OSPF information with other OSPF routers.
This is used to work around problems that might prevent OSPF information sharing between routers.
To configure OSPF host routes, click the OSPF Host Route Settings link. To add a new OSPF Route, click the Add button.
Configure the setting in the menu that appears. The Add and Modify menus for OSPF host route setting are nearly identical.
The difference being that if you are changing an existing configuration you will be unable to change the Host Address. To
change an existing configuration, click on the hyperlinked Host Address in the list for the configuration you want to change
and proceed to change the metric or area ID. To eliminate an existing configuration, click the
in the Delete column for
the configuration to be removed.
FFigure 6- 100. OSPF Host Route Settings table
Use the menu below to set up OSPF host routes.
Figure 6- 101. Add/Modify OSPF Host Route Settings
Specify the host route settings and click the Applybutton to add or change the settings. The new settings will appear listed
in the OSPF Host Route Settings list. To view the previous window, click the
Show All OSPF Host Route Entries
link to
return to the previous window.
The following fields are configured for OSPF host route:
Parameter Description
Host Address
The IP address of the OSPF host.
Metric
A value between 1 and 65,535 that will be advertised for the route.
Area ID
A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies
the OSPF area in the OSPF domain.
165