D-Link xStack DXS-3350SR Installation & User Manual - Snmp Host Table
DXS-3350SR Gigabit Layer 3 Switch
SNMP Host Table
Use the SNMP Host Table to set up SNMP trap recipients.
Open the SNMP Manager folder and click on the SNMP Host Table link. This will open the SNMP Host Table page, as
shown below.
To delete an existing SNMP Host Table entry, click the corresponding
under the Delete heading.
To display the current settings for an existing SNMP Group Table entry, click the blue link for the entry under the Host IP
Address heading.
Figure 7- 35. SNMP Host Table
To add a new entry to the Switch's SNMP Host Table, click the Add button in the upper left-hand corner of the page. This
will open the SNMP Host Table Configuration page, as shown below.
Figure 7- 36. SNMP Host Table Configuration
The following parameters can set:
Parameter Description
Host IP Address
Type the IP address of the remote management station that will serve as the SNMP
host for the Switch.
SNMP Version
V1 - To specifies that SNMP version 1 will be used.
V2 - To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv - To specify that the SNMP version 3 will be used, with a
NoAuth-NoPriv security level.
V3-Auth-NoPriv - To specify that the SNMP version 3 will be used, with a Auth-
NoPriv security level.
V3-Auth-Priv - To specify that the SNMP version 3 will be used, with a Auth-Priv
security level.
Community String or
SNMP V3 User Name
Type in the community string or SNMP V3 user name as appropriate.
210
To implement your new settings, click Apply. To return to the SNMP Host Table, click the
Show All SNMP Host Table
Entries
link.