D-Link xStack DXS-3350SR Installation & User Manual - Dns Relay Static Table
DXS-3350SR Gigabit Layer 3 Switch
Configuring DNS Relay Information
To configure the DNS relay function on the Switch, open the Configuration folder to Layer 3 IP Networking, and click
the DNS Relay folder. In this folder, click the DNS Relay Information link to open the following window.
Figure 6- 104. DNS Relay Information window
The following fields can be set:
Parameter Description
DNS Relay Status
<Disabled>
This field can be toggled between Disabled and Enabled using the pull-down menu, and
is used to enable or disable the DNS Relay service on the Switch.
Primary Name Server
<0.0.0.0>
Allows the entry of the IP address of a primary domain name server (DNS).
Secondary Name
Server <0.0.0.0>
Allows the entry of the IP address of a secondary domain name server (DNS).
DNSR Cache Status
<Disabled>
This can be toggled between Disabled and Enabled. This determines if a DNS cache
will be enabled on the Switch.
DNS Static Table
Status <Disabled>
This field can be toggled using the pull-down menu between Disabled and Enabled.
This determines if the static DNS table will be used or not.
Click Apply to implement the new settings.
DNS Relay Static Table
To view the DNS Relay Static Table, open the DNS Relay folder in the Configuration folder to Layer 3 IP Networking,
and click the DNS Relay Static Table link, which will open the following window.
Figure 6- 105. DNS Relay Static Table
To add an entry into the DNS Relay Static Table, simply enter a Domain Name with its corresponding IP address and
click Add. A successful entry will be presented in the table below, as shown in the example above. To erase an entry from
the table, click the
corresponding to the entry you wish to delete.
168