D-Link xStack DXS-3350SR Installation & User Manual - Static/default Route
DXS-3350SR Gigabit Layer 3 Switch
Static/Default Route
Entries into the Switch’s forwarding table can be made using both MAC addresses and IP addresses. Static IP forwarding is
accomplished by the entry of an IP address into the Switch’s Static IP Routing Table.
Figure 6- 84. Static/Default Routes Settings window
This window shows the following values:
Parameter
Description
IP Address
The IP address of the Static/Default Route.
Subnet Mask
The corresponding Subnet Mask of the IP address entered into the table.
Gateway
The corresponding Gateway of the IP address entered into the table.
Hops
Represents the metric value of the IP interface entered into the table. This field may
read a number between 1-65535 for an OSPF setting, and 1-16 for a RIP setting.
Protocol
Represents the protocol used for the Routing Table entry of the IP interface. This field
may read OSPF, RIP, Static or Local.
Backup State
Represents the Backup state that this IP interface is configured for. This field may read
Primary or Backup.
Click the
if you would like to delete this entry from the Static/Default Route Settings table.
To enter an IP Interface into the Switch’s Static/Default Routes window, click the Add button, revealing the following
window to configure.
Figure 6- 85. Static/Default Routes Table – Add a New Entry
136