D-Link xStack DXS-3350SR Installation & User Manual - Save Changes
DXS-3350SR Gigabit Layer 3 Switch
Save Changes
The DXS-3350SR has two levels of memory; normal RAM and non-volatile or NV-RAM. Configuration changes are made
effective clicking the Apply button. When this is done, the settings will be immediately applied to the switching software in
RAM, and will immediately take effect.
Some settings, though, require you to restart the Switch before they will take effect. Restarting the Switch erases all settings
in RAM and reloads the stored settings from the NV-RAM. Thus, it is necessary to save all setting changes to NV-RAM
before rebooting the switch.
To retain any configuration changes permanently, click on the Save button in the Save Settings window, as shown below.
Figure 9- 6. Save Settings window
The Switch has three levels of save, which are as follows:
Parameter
Description
Save (Only save
config)
Clicking the radio button for this entry will save only the current switch configuration to
NV-RAM.
Save Log (Only save
log)
Clicking the radio button for this entry will save only the current log file to NV- RAM.
Save All (Save config
and log)
Clicking the radio button for this entry will save both the current switch configuration
and the current log file to NV-RAM.
Once the Switch configuration settings have been saved to NV-RAM, they become the default settings for the Switch, and
one of the following three windows will appear depending on which option you choose in the Save Settings window.
Figure 9- 7. Save Settings window (only save configuration)
247