D-Link xStack DXS-3350SR Installation & User Manual - Policy & Parameters
DXS-3350SR Gigabit Layer 3 Switch
Policy & Parameters
This command will enable an administrator-defined authentication policy for users trying to access the Switch. When
enabled, the device will check the Login Method List and choose a technique for user authentication upon login.
To access the following window, click Security Management > Access Authentication Control > Policy & Parameters:
Figure 7- 5. Policy & Parameters Settings window
The following parameters can be set:
Parameters Description
Authentication Policy
Use the pull down menu to enable or disable the Authentication Policy on the
Switch.
Response Timeout (0-
255)
This field will set the time the Switch will wait for a response of authentication from
the user. The user may set a time between 0 and 255 seconds. The default set-
ting is 30 seconds.
User Attempts (1-255)
This command will configure the maximum number of times the Switch will accept
authentication attempts. Users failing to be authenticated after the set amount of
attempts will be denied access to the Switch and will be locked out of further
authentication attempts. Command line interface users will have to wait 60
seconds before another authentication attempt. TELNET and web users will be
disconnected from the Switch. The user may set the number of attempts from 1 to
255. The default setting is 3.
Click Apply to implement changes made.
184