D-Link xStack DXS-3350SR Installation & User Manual - Ospf Interface Configuration
DXS-3350SR Gigabit Layer 3 Switch
The Area ID Settings are as follows:
Parameter
Description
Area ID
A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies
the OSPF area in the OSPF domain.
Type
This field can be toggled between Normal and Stub using the pull down menu.
Stub Import
Summary LSA
Displays whether or not the selected Area will allow Summary Link-State
Advertisements (Summary LSAs) to be imported into the area from other areas.
Stub Default Cost
Displays the default cost for the route to the stub of between 0 and 65,535. The default
is 0.
OSPF Interface Configuration
To set up OSPF interfaces, click the OSPF Interface Settings link to view OSPF settings for existing IP interfaces. If there
are no IP interfaces configured (besides the default System interface), only the System interface settings will appear listed.
To change settings for in IP interface, click on the hyperlinked name of the interface to see the configuration menu for that
interface.
Figure 6- 94. OSPF Interface Configuration
Figure 6- 95. Edit OSPF Interface Settings menu
160