Riso 570 User Manual - Changing Default Settings
Advanced Features
Changing Default Settings [Admin.]
161
Changing Default Settings
[Admin.]
The default settings can be modified to best suit your needs.
They may be edited as needed.
Important!:
• If the administrator is registered in User Management, only the administrator can change the
[Admin.]
settings.
(This operation requires input of the administrator's PIN code or connection of the registered USB Flash Drive.)
)
p.168,
)
p.104
• Depending upon the usage environment, the “Admin.” features may not be available (the “Admin.” tab may not be
displayed).
Consult your dealer (or authorized service representative) for details.
Note:
• The default settings are the values restored when the machine is turned ON or when the
key is pressed.
Configurable Functions
:Initial setting (factory default)
Display Access
Button
Functions
Description
[Display]
DirectAccess Entry
Store frequently-used functions on the Basic Screen
for each mode.
)
p.171
Selections Entry
Store frequently-used functions on the Selections
screen for each mode.
)
p.171
Display Priority
Select first screen to display following the Startup.
Note:
• The Mode Screen is available only when “Mode Key
Pattern” is set to “Mode Selection”.
Mode Screen/RISO Print/
(Scanning)
Mode Key Pattern
Select screens to display when the
key is
pressed.
[Mode Selection]
Pressing the
key will open the Mode Screen no
matter which screen you are currently on.
[Loop]
The screen changes as shown below when the
key is pressed.
• Normally: “Master Making Basic Screen”
←→
Basic Screen”
• When the optional Document Storage Card DM-
128CF or USB Flash Drive is attached: “Scan Basic
Screen”
←→
“Master Making/Print Basic Screen”
Mode Selection/Loop
CAN_EN.book Page 161 Friday, September 21, 2007 10:42 AM