Riso 570 User Manual - page 207

Replacing Consumables

Replacing the Master Roll

203

5 

Open the Master Roll Holder.

6 

Remove the depleted Master core.

Note:

• Dispose the depleted master core according to 

the disposal rule of your local community.

)

p.212

7 

Install a new Master Roll.

Remove the plastic shrink wrap from the new 

Master Roll, and place in with the 

 mark to the 

left. 

Important!:

• Take care not to damage the 

 section when 

removing the shrink wrap. 

If the 

 section is bent or the perforation cut, 

the master will become unusable. 

• Do not remove the tape yet.

8 

Close the Master Roll Holder.

Remove the tape once the Master Roll Holder has 

been closed.

9 

Insert the leading edge of the master 

under the Master Guide Flap.

Insert the leading edge of the master into its 

entrance under the Master Guide Flap and 

advance it as far in as it will go (

). If the Master 

is loose, turn the flange at the right towards the 

rear and rewind (

). 

Master Roll Holder

Do not remove

the tape

Flange

Master Guide Flap

CAN_EN.book  Page 203  Friday, September 21, 2007  10:42 AM