Riso 570 User Manual - page 39

Basic Operations

Preparing to Print

35

Setting up the Paper Receiving Tray

1 

Open the Paper Receiving Tray.

Pull the Paper Receiving Tray down until it comes 

to a rest.

2 

Position the Receiving Tray Paper 

Guides.

1) 

Raise the Receiving Tray Paper Guides.

2) 

Hold their lower part and slide them to fit the 

paper width.

Important!:

• For thick paper such as drawing paper, position 

the Receiving Tray Paper Guides a little wider 

than the actual paper width.

3 

Set the Paper Stopper.

1) 

Raise the Paper Stopper.

2) 

Slide to fit the length of the paper.

4 

Adjust the Paper Arrangers.

Alignment of paper is affected by sizes and 

strength of paper. Adjust the Paper Arrangers so 

that printed paper is aligned.

Press the Paper Arranger to push the plates out, 

pull up to pull them in.

For plain paper

Press to open all of the four Paper Arrangers.

For plain paper with images 

lopsided on page

Press to open the two Paper Arrangers on the 

more heavily printed side.

For thick paper

Press to open the two Paper Arrangers (right 

and left) closer to the machine.

CAN_EN.book  Page 35  Friday, September 21, 2007  10:42 AM