Riso 570 User Manual - page 224
Troubleshooting
When a Message Displays
220
B00-000:Optional Device Errors (in alphabetical order)
Master Remains on Print Drum
(Cylinder)
Pull Out Print Drum (Cylinder) and
Remove Master
An unnecessary master
remains on the Print Drum
(Cylinder).
1)
Pull out the Print Drum (Cylinder) and
remove the master from the drum (cylinder).
)
p.209
2)
Return the Print Drum (Cylinder) in place.
3)
Press the
key.
Safety SW on Standard Feed Tray
is Activated
Reset paper on Standard Feed Tray
The safety switch for the
Standard Feed Tray (Paper
Feed Tray) has been activated.
Check underneath the Standard Feed
Tray (Paper Feed Tray) and on top of the
printing paper for any obstructions.
Remove if any exist.
System Error in Master Making Unit
Take Out Master and then
Close Master Making Unit Cover
The cutter mechanism for the
master malfunctioned.
Pull out the Master Making Unit and
remove the master.
)
p.202
Closing the Master Making Unit Cover will
reset the error. Setup the master again.
Message
Possible Cause
Action
Can not identify
• Something other than the
USB Flash Drive is
connected to the USB slot.
• A defective USB Flash Drive
is connected to the USB slot.
• A USB Flash Drive not
recognized for this machine
is connected to the USB slot.
Connect a USB Flash Drive for this
machine.
)
p.11
Insufficient free space of the
USB Flash Drive.
Connect the USB Flash Drive to the USB
slot after increasing the free space of USB
Flash Drive by a computer.
Can not identify (USB hub)
A USB hub is connected to the
USB slot.
Connect the correct corresponding USB
Flash Drive.
)
p.11
Check Sorter’s Panel Display
Optional sorter error.
Check the sorter’s panel. See the
instruction manual of the sorter for its
operations.
Close Sorter’s Cover
Optional sorter cover is open.
Close the sorter cover.
Insert Card in Key/Card Counter
No card in the Key Card
Counter (option).
Insert Card in the Key Card Counter.
!! Job Separator is OFF !!
Turn On Power Switch of it
The Job Separator (option) is
turned OFF.
Turn on the Job Separator.
No IP Address Assigned to This
Printer
Contact Your Network Administrator
IP address for the machine is
not properly set.
Contact your system administrator and set
the machine IP address correctly.
)
p.164
No Paper Tape in Job Separator
Replace Tape Roll
No tape in the Job Separator
(option).
Load new tape into the Job Separator.
Message
Possible Cause
Action
CAN_EN.book Page 220 Friday, September 21, 2007 10:42 AM