Riso 570 User Manual - page 243
Troubleshooting
Troubleshooting
239
Multi-up did not function.
There is nothing printed on
one side.
Did you place the second original in
time after the beep, while the
message “Place Another Original and
Press Start Key” was showing?
When you print using “Multi-Up”, the
machine will beep during the Multi-Up
Interval. Place the second original during
that interval.
If the machine starts scanning for the second
time without a beep, even when you are
scanning from the Glass Platen, you will
need to adjust “Multi-Up Interval” settings on
the Admin. screen.
)
p.165
Did you accidentally press the
key while the original was being
scanned?
The print operation will stop if the
key
is pressed while scanning is in progress.
Do not press the
key until all originals
have been scanned.
The left and right print
positions have been shifted.
The left and right print positions have
not been adjusted for the center.
The Paper Feed Tray is equipped with the
Horizontal Print Position Adjustment Dial.
Lower the tray, adjust the position, and then
perform proof copy to check the position.
)
p.90
Paper sticks to the surface of
the Print Drum (Cylinder).
The margin at the top of the original or
print is too small.
The margin of the original (top of the print in the
paper output direction) must be 5 mm (
3
/
16
") at
least. Lower the vertical print position. If this
adjustment is impossible, reproduce an original
with enough margin and perform the master-
making operation again.
)
p.55
The print paper is inappropriate.
Use the recommended paper.
)
p.15
The original has a solid black portion
at its top.
If an original has a solid black portion at
the top, printed copies may not properly
output. Replace the original in the reverse
direction and restart the master-making
process.
Printed and curled copies are
output.
The print paper is loaded at a
horizontal grain direction.
Load print paper with a vertical grain
direction.
Paper gets jammed in the ADF
unit (Option).
There is any paper caught in the ADF
unit (Option).
Pull the ADF Original Release Lever to the
right or turn the Release Original Dial and
remove the jammed paper.
Problem
Possible Cause
Action
ADF Original Release Lever
Original Release Dial
CAN_EN.book Page 239 Friday, September 21, 2007 10:42 AM