Riso 570 User Manual - page 42
Basic Operations
Printing from a Paper Document or Book
38
(PIN code Input Screen)
(Registered USB Flash Drive Screen)
The initial screen will be displayed after the user
has been identified.
4
Place the original.
Place the original on the Glass Platen or in the
ADF unit (Option).
When placing on the Glass Platen
Place the original face down on the Glass
Platen. Align center on the top edge, and close
the Platen Cover.
Magazines, books, scrap books, etc. should be
placed on the Glass Platen.
Note:
• If the Gauge Cover is installed, place the
original underneath.
When placing in the ADF unit
(Option)
Use the ADF unit if you are printing multiple
originals in succession. Place originals face-
down and then adjust the ADF Original Guides
to the width of the originals. Insert the originals
as far into the ADF unit as possible.
Note:
• For set originals, master-making and printing
are done in sequence from the top (from the last
page).
Important!:
• The ADF unit can accommodate originals of
100 mm
×
148 mm (3
15
/
16
"
×
5
27
/
32
") and above.
Smaller originals should be placed on the Glass
Platen.
• Do not place multiple originals of differing sizes
or otherwise unsuitable originals into the ADF
unit.
Doing so can cause paper jams and damage
the machine.
)
p.17
Input the PIN code
OK
Insert the registered
USB flash drive
Gauge Cover
Grasp here
and lift up the
gauge cover
Place the original
face-down
CAN_EN.book Page 38 Friday, September 21, 2007 10:42 AM