Riso 570 User Manual - page 245
Troubleshooting
Troubleshooting
241
Paper is not smoothly fed from
the Paper Feed Tray.
(skipped paper, or multiple-
sheet feeding)
The print paper is inappropriate.
Use paper that falls within the
recommended range.
)
p.15
The position of the Paper Feed
Pressure Adjustment Lever was
inappropriate.
When using thick or slippery paper, set the
Paper Feed Pressure Adjustment Lever to
CARD (
).
)
p.33
The angle of the Stripper Plate is
inappropriate.
Turn the Stripper Plate Angle Adjustment
dial as follows;
•
When the feeding skips
Turn the dial to the left.
•
When multiple sheets are fed
Turn the dial to the right.
Important!:
• Before making the adjustment, be sure
to remove all paper from the Paper
Feed Tray and confirm that the tray has
lowered to the bottom.
The Paper Feed Adjustment on the
Functions screen is not properly set.
Adjust the “Paper Feed Adj.”. Contact your
dealer (or authorized service
representative) for details on making the
adjustment.
The back of the printed card is
peeling, or the leading edge
gets wrinkled.
The angle of the Stripper Plate is in
appropriate
Turn the Stripper Plate Angle Adjustment
Dial to adjust the angle.
An error message displays
even though there is no paper
jam.
Is the lifted paper getting ejected at
the second rotation of the Print Drum
(Cylinder)?
Check the printed copy, and if the top
margin is less than 5 mm (
3
/
16
"), slightly
lower Print Position.
Is sunlight directly hitting the
machine?
The sensor is affected by direct sunlight.
Install shades or curtains, or move the
machine out of direct sunlight.
Problem
Possible Cause
Action
CAN_EN.book Page 241 Friday, September 21, 2007 10:42 AM