Riso 570 User Manual - (Color (Colour) Change)
Replacing Consumables
Replacing the Print Drum (Cylinder) (Color (colour) Change)
209
Replacing the Print Drum (Cylinder)
(Color (colour) Change)
When replacing with a Color Drum (Cylinder) to change colors (colours), or when removing jammed paper, follow the
steps to remove Print Drum (Cylinder). Be sure to use a Color Drum (Cylinder) specifically designed and approved
for use with this machine.
B
Caution:
• Do not stand the Print Drum (Cylinder) upright. Doing so may stain the floor, etc.
Important!:
• Use only Print Drums (Cylinders) specifically designed and approved for use with this machine.
• Keep the power ON while removing or replacing the Print Drum (Cylinder).
• Make sure to place the changed Print Drum (Cylinder) into the drum (cylinder) case and store horizontally.
Removing the Print Drum (Cylinder)
1
Open the Front Cover.
2
Check that the indicator of the Print
Drum (Cylinder) Release Button is
ON.
If the indicator is off, press the Print Drum (Cylin-
der) Release Button to turn it on.
Important!:
• When the Master Making Unit is out, the Print
Drum (Cylinder) cannot be pulled out. Return
the Master Making Unit into position and press
the Print Drum (Cylinder) Release button.
)
p.202
3
Pull out the Print Drum (Cylinder).
Grasp the Print Drum (Cylinder) Handle and
slowly pull until the Print Drum (Cylinder) is com-
pletely extended.
Print Drum
(Cylinder)
Release Button
Print Drum (Cylinder)
Handle
CAN_EN.book Page 209 Friday, September 21, 2007 10:42 AM