Riso 570 User Manual - page 215
Replacing Consumables
Replacing the Print Drum (Cylinder) (Color (colour) Change)
211
Installing the Print Drum (Cylinder)
1
Place the Print Drum (Cylinder) on
the Rail.
Align the
mark on the Print Drum (Cylinder)
with the
mark on the guide, and place the Print
Drum (Cylinder) horizontally onto the rail.
Note:
• If the Print Drum (Cylinder) was manually
rotated, be sure to turn it back so that
and
marks align, after it is placed on the rail.
2
Return the Print Drum (Cylinder) to
its original position.
Push the Print Drum (Cylinder) in as far as it will
go, and then close the Front Cover.
Important!:
• Do not grasp the Print Drum (Cylinder) Handle
when pushing in the Print Drum (Cylinder).
Tip:
Changing the Drum (Cylinder) Type
When you install a different type of Print Drum
(Cylinder), the Confirm Drum (Cylinder) Type
screen appears.
1)
Select the type corresponding to the installed
Print Drum (Cylinder).
2)
Touch
[OK]
.
The Print Drum (Cylinder) type is confirmed
and printing is enabled.
Important!:
• You will not be able to print until the Print
Drum (Cylinder) type is confirmed.
• If you install a non-approved Color Drum
(Cylinder), the message “Wrong-Type Print
Drum (Cylinder) Installed Replace with
Correct Type” is displayed. Install a Color
Drum (Cylinder) specifically approved for
use with this machine.
Ready to Make Master
Selections
Basic
Functions
Admin.
P.1/3
!!The Print Drum Type
has been Changed!!
Select the Current
Print Drum Type
F17
OK
A3 Drum
A4-R Drum
CAN_EN.book Page 211 Friday, September 21, 2007 10:42 AM