Riso 570 User Manual - page 231

Troubleshooting

When a Message Displays

227

F00-000:Warning Messages (in alphabetical order)

Message

Symptom/Action

How to Clear a Pop-Up Message

Auto Page Size Selection

is Not Available for

Irregular-Size Original

Select Format Size to Store

and then Restart

(Cause 1)

Attempting to scan an irregular-size 

original using “Auto” in scanning mode.

(Action)

Select the original size manually. 

(Cause 2)

A normal-size original has been set in 

the wrong position.

(Action)

Lift the Platen Cover Pad up and set the 

original correctly.

•

To specify the format for saving

Touch 

[Saving Format]

.

•

To cancel scanning 

Touch 

[Cancel]

.

(Alternatively, press the 

 key or 

the 

 key to clear.)

!! Book Shadow Editor

is Not Available

with ADF !!

Place Original on

Glass Platen

(Symptom)

ADF is disabled while Book Shadow 

function is active.

(Action)

Place the original on the Glass Platen.

)

p.77

Touch 

[Close]

.

(Alternatively, press the 

 key or the 

 key to clear.)

Check Stock of

Required Ink and

Please Order If Needed

(Symptom)

The remaining quantity of Ink Cartridge 

or Master Roll has become less than 

specified on “Stock Management”.

)

p.166

(Action)

Order Ink Cartridges or Master Rolls if 

necessary.

Touch 

[Close]

.

(Alternatively, press the 

 key or the 

 key to clear.)

Check Stock of

Required Master and

Please Order If Needed

Touch 

[Close]

.

(Alternatively, press the 

 key or the 

 key to clear.)

Check the Original Size

The Original Size is larger

than Max. Printing Area

(Symptom)

As the original size is larger than the 

maximum printing area, extra areas may 

not be printed.

(Action)

Modify the reproduction size.

•

To change the “Size” setting;

Touch 

[Size Setting]

.

•

When resuming the print job;

Touch 

[Continue]

.

(Alternatively, press the 

 key to 

print.)

•

When stopping the print job;

Touch 

[Cancel]

.

(Alternatively, press the 

 key or 

the 

 key to clear.)

Check the Settings

The Selected Reproduction

Ratio will not fit the

Max. Printing Area

(Symptom)

Reproduction size is too large for the 

detected original size and exceeds the 

maximum printing area.

(Action)

Modify the reproduction size.

•

When changing the “Size” setting;

Touch 

[Size Setting]

.

•

When resuming the print job;

Touch 

[Continue]

.

(Alternatively, press the 

 key to 

print.)

•

When stopping the print job;

Touch 

[Cancel]

.

(Alternatively, press the 

 key or 

the 

 key to clear.)

CAN_EN.book  Page 227  Friday, September 21, 2007  10:42 AM