Riso 570 User Manual - page 240
Troubleshooting
Troubleshooting
236
An error indication does not
disappear even though
consumables (ink, master roll)
are set.
The consumables (ink, master roll)
have not been correctly set.
After inserting the Ink Cartridge, turn it
clockwise (
) to lock. Or set the Ink
Cartridge again.
)
p.205
Set a master roll so that the
mark
comes to the left, and set the Master
Making Unit.
)
p.202
The Ink Cartridge does not contain
ink information.
Do not remove the label attached on the
Ink Cartridge outlet section. If you did so,
set a new Ink Cartridge.
)
p.205
The master roll does not contain
master information.
Do not remove the
section from the
master core. If you did so, set a new
master roll.
)
p.202
The Master Disposal Box
cannot be removed.
The “Protect” setting is ON.
If the “Protect” setting is ON, the Master
Disposal Box cannot usually be removed.
)
p.179
The Master Disposal Box lever is
locked.
Slide the Master Disposal Box lever to the
right to unlock.
If the Master Disposal Box is padlocked,
contact the administrator to release the
padlock.
)
p.207
There is no image on copies.
The original is placed face up.
Place the original face down. (This is also
true for the ADF unit (Option))
The master is installed with the
incorrect side out.
Reinstall the Master Roll with correctly.
)
p.202
Some areas are missing in the
printed copy.
The Glass Platen (and/or the ADF
Scanner Glass) is not clean.
Clean the Glass Platen (and/or the ADF
Scanner Glass).
)
p.215
A foreign object may exist on the
master.
Pull out the Print Drum (Cylinder) and
check if any object exists on the master. If
a foreign object exists between the master
and the drum (cylinder), remove the
master. Then set the drum (cylinder) and
perform the master-making operation
again.
• The paper size placed on the
Paper Feed Tray was not the same
as the size of the original at the
time of the master-making process.
• The Feed Tray Paper Guides were
not fit to the width of paper at the
time of the master-making process.
A master is made according to the size of
paper placed on the Paper Feed Tray;
namely the width of the Feed Tray Paper
Guides and the length of paper. If the size
of paper placed on the tray is smaller than
the size of the original, a master is not
made for the entire original. Set the same
size of paper on the tray as the original
and perform the master-making operation.
Problem
Possible Cause
Action
CAN_EN.book Page 236 Friday, September 21, 2007 10:42 AM