Objet Objet30 User Manual - page 100
Manual is about: 3-D Printer System
of
142
Operating & Maintaining the Objet30 3-D Printer
7–20
DOC-24000 Rev. C
5. In the next wizard screen, confirm that the printer cover is closed, and
click
Next
.
The wizard runs the material‐flushing cycles.
Figure 7-24: Flushing cycles in progress
6. If cleaning‐fluid cartridges are loaded in the printer, the wizard
prompts you to remove them. Confirm this in the wizard screen, and
click
Next
.
Figure 7-25: Final wizard screen
Note: After preparing the printer for an extended shutdown period with this
wizard, run the Shutdown Wizard to complete the shutdown process.