Objet Objet30 User Manual - page 107
DOC-24000 Rev. C
7–27
Objet30 User Guide
6. When the following screen appears, open the cover.
Figure 7-38: Wiper Cleaning wizard during steps 7–10
7. Put on the cleaning gloves.
8. Using a generous amount of cleaning fluid and the cleaning cloth,
remove any material remaining on the wiper and the surrounding
area.
9. Inspect the wiper.
If the wiper is scratched, torn or worn, or if you cannot clean it
completely, replace it.
a. With the M2.5 Allen key, loosen (but do not remove) the screw
securing the wiper.
Wiper and excess-material drain
b. Grasp the wiper unit and remove it.
c. Insert the new wiper, making sure that it is level, and tighten the
securing screw.
10. In the wizard screen (see figure 7‐38), confirm that the wiper blade is
clean, and click
Next
.
11. Make sure that you have removed all tools and cleaning materials
from the printer, and close the cover.
Wiper
Securing
screw