Objet Objet30 User Manual - page 130
Manual is about: 3-D Printer System
of
142
Operating & Maintaining the Objet30 3-D Printer
7–50
DOC-24000 Rev. C
4. Disconnect the UV lamp cable and the fan cable.
Figure 7-72: Disconnecting the UV lamp assembly
5. Loosen the two side screws securing the UV lamp assembly to the
printer.
Figure 7-73: UV-lamp-assembly
6. Remove the assembly, and place it on a flat surface.
UV-lamp connector
UV-fan connector
Securing
screws