Objet Objet30 User Manual - page 127
DOC-24000 Rev. C
7–47
Objet30 User Guide
4. In the next wizard screen, observe the numbers and wait until the level
is relatively stable—two units above or below the average level shown.
Figure 7-66: Load cell calibration screen
5. Select the Weight is stable check box, and click
Next
.
If you need to calibrate more than one load cell, the next calibration
screen appears. Repeat steps 4 and 5 until all of the load cells are
calibrated.
6. Click
Done
in the final wizard screen.
Figure 7-67: Final wizard screen
If you removed the waste container, make sure to replace it with its metal
cover, and make sure that the drain tube is not bent. Operating the printer
without the waste-container cover results in an inaccurate measurement of
the waste weight, which will cause waste to overflow into the printer.