Objet Objet30 User Manual - page 19
DOC-24000 Rev. C
2–7
Objet30 User Guide
Waste Disposal
Fully cured printed models can be disposed of as ordinary office trash.
However, special care is required when handling printer waste.
¾
When removing the waste container from the Objet30 printer, wear
neoprene or nitrile gloves.
¾
To prevent liquid waste from splashing into the eyes, wear safety
goggles.
¾
Liquid waste from the Objet30 printer is classified as hazardous
industrial waste. Therefore, printing‐material waste must be packaged
and disposed of in a manner that prevents human contact with it and
contamination of water sources.
¾
Empty model‐material and support‐material cartridges contain residue
of their contents. Some leakage of this residue may occur through the
broken cartridge seal. Therefore, handle and store empty cartridges
with care.
¾
Do not attempt to reuse empty cartridges, and do not puncture them.
¾
Dispose of used cartridges and waste containers in accordance with
local regulations.
¾
Discard contaminated clothing, shoes, empty containers, etc., in
accordance with any applicable regulations.