Objet Objet30 User Manual - page 64
Using Objet Studio
5–30
DOC-24000 Rev. C
To open an objzf file:
1. From the File menu, select
Import Packed Job…
2. In the Open dialog box, display the appropriate folder and select the
file.
3. In the Browse for Folder dialog box, display the folder in which you
want Objet Studio to expand the compressed file, and click
OK
.
The objtf file and associated stl files are expanded and placed in the
selected folder, and the tray is displayed in Objet Studio.
Advanced-Mode Features
The Objet Studio features described in this section are only accessible if the
application is set to Advanced mode.
To see the current Objet Studio setting:
¾
Open the Tools menu.
Figure 5-40: Tools menu, showing Advanced mode selected
If Advanced is checked, the advanced features are enabled.
To change the Advanced setting:
1. Click
Advanced
in the Tools menu.
The following message is displayed, reminding you that the change
will only take effect the next time you open Objet Studio—even though
the check mark in the Tools menu appears/disappears after you make
the change.
Figure 5-41: Configuration-change message
2. Close and re‐open Objet Studio to access the Advanced mode features.