Objet Objet30 User Manual - page 75
DOC-24000 Rev. C
6–7
Objet30 User Guide
Server Job Manager
When you open the server Objet Studio / Job Manager program for the first
time, or if the program is not connected to an Objet 3‐D printer, you are
prompted to connect to a printer. If you click
Yes
in the dialog box, the
Setting Network Connection dialog box opens (see figure 6‐6).
You can switch the server connection to another printer at any time.
To set (or change) the printer connection:
1. From the 3D Printer menu, select
Set Printer
.
2. In the Set Printer dialog box, click
Connect...
Figure 6-6: Printer connection dialog box
3. Type the name of the computer inside the printer, or click
Browse
to
find and select it. Click
OK
to close the dialog box.
To connect to a printer, the printer must be on and connected to the local
network.