Objet Objet30 User Manual - page 98
Operating & Maintaining the Objet30 3-D Printer
7–18
DOC-24000 Rev. C
4. When completely shutting down the Objet30 printer and turning the
power off, select
Yes
and click
Next
.
5. After the printer computer shuts down, turn off the main power switch
(at the back of the printer) (see figure 7‐2 on page 2).
Material
Flush/Fill
Wizard
You use this wizard to prepare the printer for a shutdown of more than one
week, and to restore the printer to working condition.
•
To prepare the printer for an extended shutdown, the wizard drains
printing materials from the print heads, then flushes the system with
cleaning fluid. This process takes about 60 minutes.
For this procedure, you need to load four (4) cleaning‐fluid cartridges in
the cartridge drawer.
•
To restore the printer to working condition, the wizard fills the system
with printing materials. This process takes about 30 minutes.
For this procedure, you need to load two (2) cartridges of model
material and two (2) cartridges of support material.
To run the Material Flush/Fill Wizard:
1. Select
Material Flush/Fill Wizard
from the Options menu.
2. In the opening screen, click
Next
.
Figure 7-21: Wizard procedure selection
3. Select the required procedure, and click
Next
.
Note: Before continuing, make sure the required cartridges of material are
available for the procedure selected.