Objet Objet30 User Manual - page 121
Manual is about: 3-D Printer System
of
142
DOC-24000 Rev. C
7–41
Objet30 User Guide
11. Confirm that the heads are level and even by selecting the check box in
the following wizard screen, and click
Next
.
Figure 7-54: Installation-check screen
12. In the next wizard screen, select the check box to confirm that you have
removed all tools and objects from the printer.
Figure 7-55: Cleared-tray confirmation screen
13. Close the printer cover.
The wizard continues by filling the heads, then heating and purging them.
If there are no installation problems, the weight calibration procedure
begins (see “Weight Calibration” on page 7‐44).
If a vacuum leakage is detected, or if there are other problems, the wizard
alerts you and instructs you how to continue (see “Installation Problems,”
next).